Expert Reviews, Buying Guides & Tips for Every Woodworker
Here’s a confession every woodworker eventually makes, usually right after a close call: for years, you probably ripped narrow stock with nothing but a scrap of plywood and a prayer. So let’s settle the push stick vs push block for table saw safety debate properly, because the difference isn’t cosmetic — it’s the gap between … Read more
Here’s an uncomfortable statistic to sit with for a second: table saws are involved in tens of thousands of hand and finger injuries in U.S. workshops every year, and a huge share of them trace back to the same root cause — a hand that got too close to a spinning blade because nothing was … Read more
Here’s an uncomfortable truth about woodworking: the tool most likely to save your fingers costs less than a large pizza. If you’ve been searching for top rated push sticks under $20, you’re already doing the smart thing — thinking about safety before an accident forces you to. Table saws don’t care how many YouTube videos … Read more
Here’s a confession every woodworker eventually makes: the first time someone said “just clamp on a sacrificial fence,” you nodded like you understood, then went home and stared at your table saw’s rip fence wondering what exactly you were supposed to sacrifice. You’re not alone, and honestly, the terminology in this hobby seems designed by … Read more
Your cabinet saw is the anchor of the shop — heavy, accurate, and honestly a little smug about it. But the factory fence bolted to it is usually just… fine. It rips straight, it locks down, and it does the bare minimum. A fence accessory kit for cabinet saw owners is how you close that … Read more
Somewhere in every woodworker’s shop there’s a moment of quiet betrayal: you measure twice, cut once, and the board still comes out three-sixteenths short. Nine times out of ten, it isn’t your tape measure or your eyeballing — it’s your fence. A stock table saw fence is basically a straightedge with delusions of precision, and … Read more
There’s a specific kind of frustration that only table saw owners understand: you finally get a clean, dead-straight rip going, and then the tail end of an 8-foot board droops off the back of the table like a fishing rod with something heavy on the line. That sag doesn’t just look awkward — it pulls … Read more
Run a dado stack an inch into a $300 aluminum extrusion fence exactly once, and you’ll understand why woodworkers have been screwing throwaway boards onto their saws since the stacked dado set was invented. It’s a five-minute fix for a mistake that costs a lot more than five minutes to undo. A sacrificial fence for … Read more
Somewhere in every woodworker’s shop there’s a drawer full of half-finished jigs — a crosscut sled with no stop block, a taper jig held together with hope and hot glue, a featherboard clamped on with a C-clamp that slips every third cut. The fix for almost all of it is the same humble strip of … Read more
Here’s a confession every woodworker eventually makes, usually through gritted teeth: you tapped the fence a hair too far, ripped a board, and now it’s 1/32″ shy of what you needed. Again. A fence micro adjuster for precision cuts exists specifically to end that ritual — it swaps the rubber-mallet guessing game for a dial, … Read more