Push Sticks & Push Blocks

Somewhere in every small shop’s history there’s a moment where a board catches, a hand gets a little too close, and the woodworker mutters “I really need to buy one of those.” A push block for a jointer and table saw combo is exactly that: a handheld safety tool — usually a rubber-or-foam-soled block with … Read more

Rip a 3/8″ strip off a board with your bare hand hovering six inches from a spinning blade, and you’ll understand exactly why this push block system for narrow rip cuts review exists. Narrow rips are the single most nerve-wracking cut on a table saw. The offcut is skinny, the blade guard usually gets in … Read more

Here’s a confession every woodworker eventually makes, usually right after a close call: the little plastic push stick that shipped with your table saw was never built for thin strips. It’s fine for shoving a two-inch board past the blade. Ask it to control a 3/16″ sliver of walnut, though, and you’re basically steering a … Read more

Here’s a scene every table saw owner knows by heart: you’re mid-cut, the fence is set, the dust collector is humming, and you reach for your push stick — except it’s not there. It’s on the bench. It’s under a pile of offcuts. It’s somewhere in the garage entropy zone, three projects deep. That five-second … Read more

Walk into ten different home shops and you’ll find ten different push sticks — half of them buried under sawdust in a drawer nobody wants to dig through mid-cut. That’s the actual problem a magnetic push stick for table saw storage solves, and it’s smaller and smarter than most people expect. Instead of hunting for … Read more

If you’ve ever stood at a table saw and felt your hand cramp around a push block built for someone twice your size, you already know the problem this article solves. An ergonomic push block set for small hands isn’t a gimmick or a “nice to have” — it’s the difference between a shop tool … Read more

An ergonomic push block for arthritis or hand pain is a woodworking safety tool built with a wider, cushioned, or angled handle so the workpiece gets gripped by the tool’s mechanism instead of your knuckles, letting sore or stiff joints feed stock past a blade with far less squeezing effort. If you’ve ever finished a … Read more

Here’s a confession every woodworker eventually makes, usually right after a close call: for years, you probably ripped narrow stock with nothing but a scrap of plywood and a prayer. So let’s settle the push stick vs push block for table saw safety debate properly, because the difference isn’t cosmetic — it’s the gap between … Read more

Here’s an uncomfortable statistic to sit with for a second: table saws are involved in tens of thousands of hand and finger injuries in U.S. workshops every year, and a huge share of them trace back to the same root cause — a hand that got too close to a spinning blade because nothing was … Read more

Here’s an uncomfortable truth about woodworking: the tool most likely to save your fingers costs less than a large pizza. If you’ve been searching for top rated push sticks under $20, you’re already doing the smart thing — thinking about safety before an accident forces you to. Table saws don’t care how many YouTube videos … Read more