Aftermarket Fence Systems

Ask any framer who’s spent a summer chasing a bouncing rip fence around a jobsite, and they’ll tell you the same thing: a fence that drifts is worse than no fence at all, because at least you know to double-check a freehand cut. A t-square fence for jobsite table saws is a rip-fence design that … Read more

Here’s the thing nobody tells you when you buy a contractor saw: the fence is almost always the weak link. The motor’s fine. The cast-iron top is fine. But that stamped-steel rip fence wiggles half a degree every time you touch it, and suddenly your “precise” cut isn’t. If you’ve ever fought a fence that … Read more

Here’s the moment every table saw owner eventually hits: you’re ripping a board, the cut drifts a hair wide at the back end, and you realize your fence has been lying to you the whole time. That’s usually the exact week someone in a forum tells you to “just get a Biesemeyer.” A biesemeyer style … Read more

Every cabinet saw eventually hits the same wall: the fence. The motor’s fine, the trunnions are dead-on, the cast iron top is flat enough to check with a straightedge and not lose sleep — and yet every rip still feels like a negotiation. That wobble when you lock the handle down. The scale that lies … Read more

A table saw fence system under $250 is a rail-and-fence upgrade that replaces or reinforces your saw’s factory rip fence, giving you a straighter, more repeatable reference edge for under two-hundred-fifty dollars. If you’ve ever ripped a board and watched the cut wander a sixteenth of an inch wider at the far end than at … Read more